how to fix a leaky bathtub faucet

how to fix a leaky bathtub faucet

How to fix a leaky bathtub Faucet

A leaky faucet may seem no big deal. But, did you know that a leaking faucet dripping at the rate of one drop per second can waste over 4000 gallons of water in one year? Can you believe that amount of water is equivalent to over sixty bath tabs?

Whether you love a relaxing bath or shower, your bathtub is one of the dearest parts of your home. Having a leaking faucet can be annoying. Even worse, become seriously damaged if not fixed on time. It is, therefore, important to fix a leaky faucet on time to save money on water bills and also prevent annoying stains in your bathtub.

Causes of a Leaky Bathtub Faucet

Leaking bathtub faucet start as few drops of water and become worse with time if not repaired. The leaks may seem small but can lead to costly water bills with time. Also, they can make you spend money to repair the floor and wall caused by the leaking water. Below are some reasons that can make your bathtub faucet to leak.

Loose Handles

Loose handles are one of the most common reasons for leaky faucets. Over time, twisting the handles while opening and closing loosen the screws and nuts. The nuts and screws are responsible for keeping the handles tight. To fix this problem, you only need to tighten the loose parts.

Worn out Washers

Faucet washers are located in the faucet’s handle. Over time, the water reacts with the rubber or plastic material of the washer ring and making it to leak. Replacing the washer is an easy task, and you can do it by yourself. You should always replace immediately you notice any leakages.

Hard Water Buildup

If the supply of water is hard water, chances are that you will see the buildup in the pipes or valves. Excess build-up can cause your faucet to leak. To clean your faucet, you need to remove and soak the handle in a hard water cleanser.

Steps to Fixing a Leaking Bathtub Faucet

You do not need to put up with a leaking faucet. Make a point of fixing it to save you from unnecessary headaches. The entire fixing job may cost you some money, but it is much cheaper than hiring licensed plumbers to do it for you. Worn out washers are the common reasons for a leaking faucet. Below are some steps to follow when replacing your faucet’s washer.

Step 1: Make sure to Purchase new Parts

The first step when fixing your leaking faucet is to have a new washer to replace the old one. The faucet replacement parts are available in hardware stores. To successfully do this, you need to know the exact model of your faucet. This will help you buy the exact washer for your faucet. Remember, there are many different makes and models of faucets. You need to know what you have so that it can be a perfect match.

Step 2: Disassemble Your Faucet

Before disassembling your faucet, you need to shut off the water supply. Also, it is necessary to drain excess water from the valve. Carefully remove the handle insert using a pocket knife.

Next, remove the handle screw. Remove the handle by wiggling and pulling it off. With time, corrosion can make the handle to weld on the stem. Do not force to come off since it could break. Instead, use a hair dryer to free it from the stem.

Step 3: Replace the Washer

To replace your washer, you need to remove the seat washer screw from the stem. This will enable you to remove the worn out washers. Use a pocket knife to pry them off. Now it is the perfect time to replace your washer with a brand new one. Go ahead and replace both the washers and the seat washer screws with new ones.

Step 4: Screw back your Faucet and Test it

Use a screwdriver to screw the handles back into place. Don’t screw the handles too tight since it might be difficult to open the next time you are fixing your faucet. Once the handle is back in place, push back the handle insert firmly in place. Turn the back the water supply and turn on the faucet to check if everything is working well. If fixing the faucet was successful, there should be no leak after turning the faucet off.

If your bathtub faucet still leaks after replacing the washer, you should consider hiring a plumber to access the problem. Your faucet may have issues with the grout, cracked piped and corrosion that could need immediate attention.

If the above tips don’t help and you live in New Jersey then feel free to contact Sayan Plumbing of Begen County

Leave a Reply

Your email address will not be published. Required fields are marked *